This standard is intended to simplify drawings.
#Din 6930 m pdf pdf#
DIN-6930-1-pdf - Free download as PDF File (.pdf) or view presentation slides online.Guidelines for general tolerances indicated on existing drawings are given in Clause 5. Technical delivery conditions for stampings are specified in DIN 6930-1. This standard is to be applied in conjunction with DIN 6932 on design rules for stamped steel parts. Cold Bending of Flat Rolled Steel Products (FOREIGN STANDARD) Add to cart DIN 7167:1987. Documents sold on the ANSI Webstore are in electronic Adobe Acrobat PDF format. If, as an exception, this standard is also applied to parts made from semi-finished products other than flat products, or from materials other than steel, this shall be agreed separately. DIN 6930-2:1989 Steel stampings general tolerances (Foreign Standard).
General tolerances for parts made by fine blanking (see VDI 2906 Part 5) are not covered by this standard. For further information about the NAFS, visit us on the Internet under ono band outtakes youtube. This standard hasbeen prepared by NA 026-00-03 AA 'Stanzteile' ('Stamped parts') of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e. They apply if this standard is referred to in drawings or associated documents (for example, terms of delivery). General tolerances according to this standard are used for cold- and warm-formed stamped parts made of flat steel products. By selection of a certain accuracy level, the normal workshop accuracy shall be considered. They are subdivided into f (fine), m (medium), g (coarse) and sg (very coarse). This standard is intended to simplify drawings and specifies general tolerances for linear and angular dimensions, concentricity and symmetry in four accuracy levels.
#Din 6930 m pdf update#
This revision primarily includes the update of the normative references and the expansion of the nominal dimension ranges and the tolerances for thickness ranges or for angles on flat stamped parts.
#Din 6930 m pdf iso#
This part of ISO 6930 applies to plates and wide-flats, hot-rolled on reversing mills, both having a thickness between 4 mm and 50 mm (inclusive). Regulations for general tolerance in existing drawings are included in clause 5.*This standard is the technical revision of the standard which has been published in 2010-01. ISO 6930-2 was prepared by Technical Committee ISO/TC 17, Steel, Subcommittee SC 3, Steels for structural purposes. DIN 6930-1 is valid for the technical delivery conditions of stamped parts. This standard shall be applied in conjunction with the specifications given in DIN 6932. If, by way of exception, it is intended to apply this standard also to components made from semi-finished products other than flat products, or from materials other than steel, this shall be particularly agreed. General tolerances for parts made by fine blanking are not covered in this standard. DIN 6930-M STAMPED STEEL PARTS ISO 13920-AF WELDINGS LINEAR AND. Republican Commissioner Robert Mc.ĭin 6930 1.pdf DOWNLOAD HERE 1 / 2. (4) Refer to “C: Proface UPDD Readmee.pdf” for the rest, the details of the setting.ġ5592559-2 (1).pdf. Interface for DIN, DOUT, Watchdog, and Remote. Designed around the Pentium®M (1.6GMHz) or Celeron®M (1.3GMHz) CPU, the.
Thank you very much for purchasing a Pro-face PL-6930/PL-7930 Unit, hereafter referred to as PL.
0 kommentar(er)
